VentureCraft Go-Dap TT Guía de usuario descargar pdf (Pagina 6)

Listening to Music in iPod/iPhone in "AMP" Mode

Turn the power ON by the power switch volume knob

and set the toggle switch (L) to "

" position.

Once this product and iPod/iPhone are correctly

connected (authenticated), the toggle switch LED turns

on red or green.

* If the toggle switch is blinking, iPod/iPhone may not be

connected with this product at all, or it may not be correctly

connected (authenticated).

In such case, disconnect iPod/iPhone once and recoonect,

or turn the power OFF by turning the power switchvolume

knob coun

terclockwise all the way until it clicks, and then

turn the power ON again.

6. Synchronizing with iPod/iPhone and

iTunes on Computer

Connect the USB micro B connector on the rear panel of

this product and your computer with the supplied USB

cable.

By setting the toggle switch (L) on the front panel to

" mode, it enables synchronization with iTunes

on your computer. "SYNC" state is the same as if iPod/

iPhone was directly connected to your computer.

CAUTION

Do not change the switches or disconnect the

microUSB cable during synchronization.

USB

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Sin comentarios

VentureCraft Go-Dap TT Guía de usuario Pagina 6